Advertisement
UNINET IMAGING INC. • OKIDATA® B6300 REMANUFACTURING INSTRUCTIONS
48. Toner hopper removed. Note the two
foam seals located at the bottom of the
hopper.
NOTES:
www.
uninet
imaging.com
11124 Washington Blvd., Culver City, California U.S.A. 90232 Ph: 310 280-9620 • Fx: 310 838-7294 • techsupport@uninetimaging.com
© 2005 Uninet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. Uninet Imaging does not guarantee or warrant downloaded information.
49. These foam seals surround holes
where toner passes through to the develop-
er roller. Residual toner can build up in
these areas, so it is important to clean
thoroughly before reinstalling the hopper.
USA
EUROPE
Ph:
+310-280-9620
+34-93-757-1335
Fx:
+310-838-7294
+34-93-741-4166
50. Clean the hopper and toner cartridge
using compressed air or a vacuum. Refill,
and reassemble the cartridge following the
previous steps in reverse.
NOTE: A new Smartchip must be fitted
after reassembly of the toner cartridge.
JAPAN
BRAZIL
+81-3-44-55-2789
+55-11-4822-3033
+310-838-7294
+55-11-4822-3353
ARGENTINA
+54-11-4574-3706
+54-11-4574-3706
Advertisement
