Advertisement
UNINET IMAGING INC. • OKIDATA® B6300 REMANUFACTURING INSTRUCTIONS
4. Remove the shutter-door arm from the
slot on the gear-side of the toner cartridge
as shown.
7. Remove the plastic pin on one end by
first drilling a hole in the center of it. This
will make it more accessible.
10. Remove the plastic pin on the opposite
end by drilling a hole in the center.
www.
uninet
imaging.com
11124 Washington Blvd., Culver City, California U.S.A. 90232 Ph: 310 280-9620 • Fx: 310 838-7294 • techsupport@uninetimaging.com
© 2005 Uninet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only. Uninet Imaging does not guarantee or warrant downloaded information.
SPRING
ARM
5. Using a hook tool, remove the shutter-
door arm on the gearless side. Remember
the spring position for re-installation.
8. Use a 2.4 mm screwdriver to turn the pin
to the "release" setting (turn counter-clock-
wise sensitively until it stops).
11. Turn the pin counter-clockwise to the
"release" setting as usual.
USA
Ph:
+310-280-9620
Fx:
+310-838-7294
ARM
EUROPE
JAPAN
+34-93-757-1335
+81-3-44-55-2789
+34-93-741-4166
+310-838-7294
6. Remove the shutter-door and set it
aside.
9. Use a 2-angle hook to access and pull
the pin from the hole.
12. Pull the pin out through the hole.
BRAZIL
ARGENTINA
+55-11-4822-3033
+54-11-4574-3706
+55-11-4822-3353
+54-11-4574-3706
Advertisement
