Table of Contents
Advertisement
10. To install and connect the wiring harnesses and switch module
A6 D1
A5
A3
2
Retrofit / Installation kit No. 84 64 0 025 816, 84 64 0 026 649
Installation instructions No. 01 29 0 025 885
13
B9
F 36 0126 M
8
A4
F 36 0149 M
The F designations marked with an asterisk
(*) are only valid for this installation and do not
refer to the after-sales service documents.
Insert fuses F1* to F4* (13) into the fuse holder
B9 as shown in the following table:
Fuse
3 A
3 A
1 A
Not occupied
Insert the fuse holder B9 into the free slot in the
joint connector box on the A pillar on the left.
The figure shows the footwell trim on the
E36/5, proceed accordingly for the other
models.
Connect branches A3, A4, A5, A6 and D1 to the
control module (2) and secure it with a small
cable tie (8).
Tie back surplus lengths of the cables and install
the footwell trim.
Issue date: 07 .2000
Slot
Cable colour
F1*
red/white and
red/black
F2*
red/white and
red/yellow
F3*
violet/white and
violet/black
F4*
violet/white and
violet/yellow
EN/35
Advertisement
Table of Contents
