Table of Contents
Advertisement
Setting Infeed Table
Height
The infeed table on the Model W1755 has positive stop
bolts that, when properly set up, allow the operator to
quickly adjust the infeed table between finish/final cuts
(top height) and shaping/heavy cuts (bottom height).
We recommend setting the minimum depth of cut to
and the maximum depth of cut to
tions. DO NOT exceed
⁄
1
or the risk of kickback and serious injury will greatly
increase!
Each positive stop bolt (Figure 57) controls the top or
bottom range of the table movement. The jam nut locks
the positive stop bolt in position so it will not move dur-
ing operation.
Calibrating Depth Scale
The depth scale on the infeed table can be calibrated or
"zeroed" if it is not correct.
To calibrate the depth scale, do these steps:
1. DISCONNECT JOINTER FROM POWER SOURCE!
2. Loosen the infeed table positive stop bolts.
3. Use the straightedge to help adjust the infeed table
exactly even with the outfeed table, as shown in
Figure 58.
4. Using a screwdriver, adjust the scale pointer to "0"
(Figure 59), then reset the infeed table positive
stops.
/
" for most opera-
1
8
" cut per pass on this machine
8
W1755 6" Parallelogram Jointer
/
"
1
32
Bottom Height
Figure 57. Positive stop bolts for infeed
Figure 59. Depth scale adjusted to "0"
-36-
Top Height
table.
position.
Advertisement
Table of Contents
