Flight Control - Walkera Starlight F420 Quick Start Manual

Starlight QUICK START GUIDE

12.0 Flight Control

1) Make sure that the GPS signal is received (the blue and red LED lights blink at the same time).
2) Only when " C onnected" displays on the upper bar of the main interface of the APP, you can
perform APP operation.
3) Please switch the flight mode before takeoff (check the current flight mode with APP).
4) Please unlock motors before takeoff. (see 11.4 for unlocking method)
Manual Takeoff or AUTO Takeoff (R emote Controller Operation)
Manual takeoff: Perform a combination stick command to start the motor and then slowly push the throttle stick
upward to take off.
AUTO Takeoff: After the motor is unlocked, the flight mode switch in GPS mode, the auto take-off/landing switch
to the "Take off" position and the aircraft automatically takes off. Hover 3.5 meters from the ground, please turn the
auto take-off/landing switch back to the middle position.
Left and right stick
(Start the motor)
Auto Takeoff is active only under GPS mode.
Auto takeoff default to 3.5m altitude, and it can be removed by pushing the throttle to midpoint or above,
whenever manual control over the throttle is needed.
After Auto takeoff, please switch the flight mode of the remote control according to your needs.
Manual Landing or AUTO Landing (R emote Controller Operation)
Manual Landing:
To land, pull down on the throttle stick to descend until the aircraft touches the ground.After
landing, push and hold the throttle stick down. The motors will stop after 5 seconds.
12
Left and right stick(start the motor)
Throttle stick(American hand is left stick)
mm
GP
a al La
Aircraft in Switch to "Take off"
GPS mode position and the aircraft
will take off automatically.
Throttle stick
a
i
Walkera All Rights Reserved
a
La i
After taking off,
turn the switch to
the middle position.