Fax Parameter - Planet Networking & Communication VGW 20FS Series User Manual

Fax Parameter

3.8.4
Explanation of fax parameters:
Fax Mode
Include "a=X-fax" Attribute
Include "a=fax" Attribute
Include "a=X-modem" Attribute
Include "a=modem" Attribute
ECM
Rate
Tone Detection by
Figure 3.10-4 Configuration Interface for Fax Parameter
There are four fax modes: T.38, T.30 (Pass-through), Modem and Adaptive.
If this parameter is enabled, "a=X-fax" attribute will be carried in SDP.
If this parameter is enabled, "a=fax" attribute will be carried in SDP.
If this parameter is enabled, "a=X-modem" attribute will be carried in SDP.
If this parameter is enabled, "a=modem" attribute will be carried in SDP.
Whether to enable 'Error Correction Mode'.
The rate of sending or receiving fax
Fax sound is detected by caller and callee automatically.
43
4-/8-/16-/24-/32-Port SIP Internet Telephony Gateway