Sending And Receiving Fax; 38 And Pass-Through - Planet Networking & Communication VGW 20FS Series User Manual

*#
*47*
*51#
*50#
*87*
*72*
*73#
*90*
*91#
*92*
*93#
*78#
*79#
*200#
Flash/Hook

2.8 Sending and Receiving Fax

The VGW-X20FS SERIES gateway supports four fax modes:
T.38 (FoIP)
Pass-through
Modem
Adaptive
T. 38 and Pass-through
2.8.1
T.38 is the preferred fax mode because it is more reliable and works well in most network conditions.
If the service provider supports T.38, please use this method by selecting T.38 as fax mode (default).
If the service provider does not support T.38, pass-through mode may be used. If you have problems
with sending or receiving Fax, toggle the Fax Tone Detection Mode setting.
Dial *# to place a call on hold
Dial *47* to establish a call through IP address
Dial *51# to enable 'call waiting' feature
Dial *50# to disable 'call waiting' feature
Dial *87* to blind transfer a call
Dial *72* to enable 'unconditional call forwarding' feature
Dial *73# to disable 'unconditional call forward' feature
Dial *90* to enable 'busy call forwarding' feature
Dial *91# to disable 'busy call forwarding' feature
Dial *92* to enable 'no answer call forwarding' feature
Dial *93# to disable 'no answer call forwarding' feature
Dial *78# to enable DND
Dial *79# to disable DND
Dial *200# to access voice mail
Used to switch between incoming calls. If the phone is not in session,
flash/hook will switch a new channel for a new call.
4-/8-/16-/24-/32-Port SIP Internet Telephony Gateway
18