ABB PVS-60-TL-US Product Manual page 112

Connection to the inverter in "AP Mode"
• Enable the wireless connection on the device which is being used for
the board setup (tablet, smartphone or PC) and connect it to the Access
Point created by the inverter system: the name of the wireless network
created by the system that the connection should be established with,
will be:
ABB-XX-XX-XX-XX-XX-XX
where "X" is a hex digit of the MAC address (MAC address can be found
on the "Communication Identification label" placed on the side of the in-
verter or applied during the commissioning phase to the plant documen-
tation).
• When required digit the PRODUCT KEY (printed on the "Communica-
tion Identification label" and applied during the commissioning phase to
the plant documentation) as access point password.
Note that it's required to digit also the dash "-" characters of the
Product Key in the password field.
In case of need, product key can be recovered by Aurora Vision Cloud of by calling ABB tech-
nical support.
• Open an internet browser (reccomended browser: Chrome versions
from v.55, Firefox versions from v.50) and enter the pre-set IP address
192.168.117.1 to access the login page.
- 112 -
7 - Operation