Table of Contents
Advertisement
INVERTER RUN
N.C.
Relay State: Idle
N.O.
SELECTED
ERROR/WARNING
OCCURENCY
ERROR MESSAGE
t=15s
N.C.
Relay State: Switched
N.O.
GRID RECONNECTION
t=based on Country Standard
N.C.
Relay State: Switched
N.O.
ERROR/WARNING
Yes
No
STILL
PRESENT
After the grid standard was set you have 24 hours to make any changes to the grid standard
value; 24 hours later the Country Standard sub-menu will be locked, and any subsequent
changes can only be made accessing with Admin Plus privileges. Refer to the dedicated
section on this topic in the manual to know how to unlock the Country Standard sub-menu.
• Alarm-Contact (alarm configurable - latch):
The relay is activated (status: switched) whenever an error (code Exxx)
or a warning (code Wxxx) is present from those selected from the list in
the dedicated submenu Output Activation Filter of the inverter display
(see the table below). When the inverter returns to the normal operating
state and reconnects with the grid.
Selectable alarms for which the relay is activated
E001
E002
E007
E010
E017
E018
E023
E025
E034
E036
E077
E078
W004
W005
W017
W046
If the alarm condition is persistent, the relay will remain activated
(status:switched)
• Alarm-Contact (alarm configurable - matrix):
In this mode, it is possible to configure the behaviour of the alarm relay
according to an error table which can be setup with the Web User Inter-
face. In the table it is possible to select the alarms or warnings for which
the alarm relay is activated (status: switched); for each individual alarm it
is also possible to select the "Latch" or "No Latch" mode.
Country Standard
By accessing to the Country Standard sub-menu you can modify the
grid standard within 24 hours while the inverter is operating.
- 132 -
E003
E004
E005
E011
E013
E014
E019
E020
E021
E029
E031
E032
E037
E053
E055
E079
E080
E084
W006
W007
W011
W047
W048
7 - Operation
E006
E015
E022
E033
E075
W002
W015
Advertisement
Table of Contents
