Table of Contents
Advertisement
HSN_3n1BlenderManual
6/25/10
Before Your First Use
Wash all parts, except Motor Housing or Cord, in warm soapy water and
dry thoroughly. Never immerse Motor Housing or Cord in water as this
will damage the unit.
Using Your Blender
6 with
rrow
Figure 1
Figure 2
Figure 3
11:06 AM
Page 7
1
Place the appliance on a flat, stable, level
surface where it cannot fall.
2
Place the Blender Jug on the Motor
Housing. Rotate the Blender Jug clockwise
as far as possible until you hear it click into
place (see Figures 1 and 2).
3
Cut the ingredients into pieces that fit in the
Jug. Do not cut into pieces that are too
large, since they will need to be small
enough to fall to the base of the Jug.
4
Place the Lid onto the Jug to prevent
splashing. The cutaway portion of the Lid
will go over the pour spout side of the
Blender Jug (see Figure 3). Place the Lid on
the Jar at a slight angle and turn clockwise
to lock into place (see Figures 4 and 5 nest
page).
5
Insert the plug into the wall outlet and turn
the power switch on the side of the Motor
Housing to the ON position.
6
Press the P(ulse) button to operate the
motor for a short period at high speed
(pulse function) or press the I button for
continuous low speed, or the II/FROZEN
DRINK button for continuous high speed.
The Standby Indicator Light will dim and the
blue indicator light for the selected function
will illuminate.
7
Using Your Blender cont.
•
Note: the Blender works very fast.
In a few seconds the ingredients will
be processed. The consistency of the
ingredients increases with longer
blend times.
7
If necessary, you can add ingredients
through the cover by removing the center
Figure 4
cap of the Lid: turn the Filler Cap counter-
clockwise and remove. If the pieces are too
large for the filling opening then switch off
the Blender, remove the Lid, and add the
ingredients. Put the Lid back on the Jug
before switching the Blender on again.
8
Once you have processed the required
Figure 5
quantity of ingredients
you can switch the appliance off (press the
button with the lit indicator light).
9
Remove the Jug from the Motor Housing by
turning it counter clockwise 90 degrees and
lifting straight up.
Automatic Frozen Drink Mode
•
Your Blender is equipped with a special
electronic function to make frozen drinks.
Press the II/FROZEN DRINK button for
more than 3 seconds to use this function.
The Blender will automatically pulse on and
off for approximately 22 seconds. This
allows the ice cubes to fall back onto the
chopping blades during processing, giving
you an even, smooth texture. You can stop
the automatic function at any time once
your drink has reached the desired consis-
tency by simply pressing the II/FROZEN
DRINK button a second time.
8
Hide quick links:
Advertisement
Table of Contents
