Making A Plug-In Cable Speaker Connection - Bose AM259777 Installation Manual

System Installation Instructions
Figure 8
A plug-in cable type
speaker
3
3
Figure 9
Speaker connections to the
Acoustimass module
12

Making a plug-in cable speaker connection

In a plug-in cable connection (Figure 8), the positive and negative wires are oriented to ensure
proper polarity.
1. Match the correct cable to the corresponding speaker location. Front speaker cables
have blue RCA connectors at one end, with L (left), R (right), or C (center) molded into
both the RCA connectors and the speaker connectors at the other end. Surround
speaker cables have orange RCA connectors at one end, with L (left) or R (right) molded
into both the RCA connectors and the speaker connectors at the other end.
2. Insert the speaker connector of each cable fully into the jack on the rear of each of the
five speakers. Match the ridge of the connector to the notch at the top of the jack.
3. Connect each cable to the corresponding jack on the Acoustimass
Plug the blue connectors into the matching left front, center, and right front jacks. Plug
the orange connectors into the matching left surround and right surround jacks.
Front speakers
Left Center
To FRONT C
To FRONT L
AM259777_02_V.pdf • April 23, 2002
Right
To FRONT R
AUDIO OUTPUTS TO
CUBE SPEAKERS
INPUT
FRONT SURROUND
POWER 100-120/200-240V AC
L
C L
R R
® module (Figure 9).
Surround speakers
Left
To SURROUND L
To SURROUND R
50/60 Hz
350W MAX.
Right