Connecting The Speakers To The Acoustimass Module; Connecting The Plug-In Cable To Jewel Cube® Speakers - Bose LIFESTYLE 18 II Series Quick Setup Manual

Figure 7
Front features of the media
center
Front door- Make sure you have
enough room to lift this door.
\
Disc tray - Make sure nothing blocks this
CO/OVD tray as it slides open.
Display window - Make sure you can see
this information while using your system.
®
The IR Emitter, which enables certain
remote control operation, is located here.
Connecting the speakers
to
the Acoustimass® module
A
CAUTION: Before you make any connections, be sure that the media center, the Acoustimass
module, and any additional equipment are not connected to AC power.
Your system may have Jewel Cube® speakers (image A on the left), which use a plug-in cable
connect, or cube array or single cube speakers (images 8 and C respectively,) which use a
two-wire cable. L1FESTYLE® DVD systems include five speakers.
Connecting the plug-in cable to Jewel Cube® speakers
) Note: If
your system has cube or cube array speakers, foJ/ow the instructions in "Making the
two-wire connections for cube or cube array speakers" on page 13.
The positive and negative wIres of the plug-in cable are properly oriented for polarity and the
plug is designed to fit only one way into the jack.
1. Match the correct cable to the corresponding speaker location:
• Front speaker cables have blue RCA connectors on one end and speaker plugs at the
other end with L (left), R (right), or C (center) markings.
• Surround speaker cables have orange RCA connectors at one end and speaker plugs
at the other end with L (left) or R (right) markings.
12