Sun Microsystems StorEdge D2 Array Best Practices Manual page 65

SCSI
cables, 2-2
commands supported, 1-3
common point of failure with cables, 5-2
configurations, 2-2
connector type, 3-2
connector types, 3-1
host IDs, 2-5
host SCSI disable, 3-1
host SCSI termination, 3-1
ID numbering for single bus, 2-5
ID numbering for split-bus, 2-6
LED, 5-5
messages, 1-3
reset, 3-2
SAF-TE processor ID, 2-5
SCSI bus maximum bus length, 2-2
send global flags command, 6-11
sense codes, A-1
setting array configurations options switch, 4-2
setting array unit ID switch, 4-2
single-bus
array option switch setting, 4-2
configuration, 2-5
drive slot numbering, 2-7
SCSI IDs illustrated, 2-7
split-bus
array option switch setting, 4-2
configuration, 2-6
drive slot numbering, 2-7
SCSI IDs illustrated, 2-7
Storage ACES web site, 1-2
Subsystem Fault LED, 5-3
Sun Cluster information, 2-2
supported configurations, 2-3
supported hardware platforms, 2-3
switch
array configuration options, 4-1
array unit ID, 4-2
T
termination power, 3-1, 3-2
LED, 5-5
troubleshooting
array failure, 5-1
SCSI cable connections, 5-2
U
unit ID switch, 4-2
using SAF-TE commands, 6-1
V
vendor unique byte definitions, 6-2
verifying
array functionality, 5-1
SCSI cable connections, 5-2
VPD
ESM card, 7-4
midplane, 7-3
VPD settings and factory defaults, 7-1 to 7-5
W
web sites
Enterprise Services Storage ACES, 1-2
Escalation Web Interface, 1-2
LSI Logic, 1-2
Network Storage, 1-2
OneStop Sun Storage Products, 1-2
QAST Group, 1-2
Sun Cluster engineering technical docs &
download information, 2-2
Sun Cluster field Q&A, 2-3
Sun Cluster home page, 2-2
Sun Cluster support matrix, 2-3
Write Buffer Commands, 6-9
write device slot status command, 6-9
Index-3