Table of Contents
Advertisement
6. Configuring
T400 can be configured with the graphic D7-ES configuring tools, based on Windows 95/NT. Thus, it is very
easy to implement even complex customized supplementary functions in the drives. Complete standard
software packages are available for functions and applications which are frequently required.
6.1. Standard software packages
The standard software packages offered, are completely generated using CFC, and can be used in SIMOVERT
MASTERDRIVES and SIMOREG DC MASTER without any additional modifications. They are parameterized via
the operator panel, OP1(S), SIMOVIS or via Profibus.
Please refer to the instructions of the appropriate standard application software packages for additional
information.
Standard software packages are presently available for:
•
angular synchronous operation
•
axial winder
•
cross cutter + flying saws
The software packages are available in the following forms:
•
The standard software package is downloaded onto the T400 as code which can run:
T400 can be immediately used. When commissioning, only a few parameters have to be set for the
particular application. The user does not have to configure using STEP 7/CFC.
•
Standard software packages as CFC source code on floppy disk:
We recommend that the source code is used if the software package has to be adapted to the particular
application, which is impossible using the existing parameters, or if a standard software package is used
very frequently.
The functions of a standard T400 software package can also be implemented on the PM5, PM6 CPU
modules using the source code. In this case, it is especially the closed-loop control-related core which can
be used. In comparison to the configuring for the T400, when porting, only the function blocks for the input,
output and communication interfaces have to be adapted to the appropriate SIMADYN D modules.
Siemens AG
SIMADYN D Hardware Brief Description
Edition 04.00
Configuring
19
Advertisement
Table of Contents
