Table of Contents
Advertisement
Installation
2. Installation
2.1. Installing the module
2.1.1. SRT400
If only one T400 is used, then this is inserted in the lefthand slot. The optional 2
communications module) is inserted at the right. The modules are retained using screws above and below the
handles which are used to insert/withdraw the modules.
2.1.2. Electronics box in the MASTERDRIVE / DC MASTER
Slot in the electronics box
Left
Slot 1 (CUx)
Center
Slot 3 (options)
Right
Slot 2
Note:
The T400 must always be inserted at slot 2 (right!!!), if it is used in a MASTERDRIVE or DC MASTER.
It is not permissible to use a TSY or the terminal expansion modules EBx (on the ADB) in conjunction with the
T400.
In order to be able to insert the option modules in
the electronics box, the LBA (Local Bus Adapter)
must be installed in the electronics box.
Installing the bus expansion LBA:
♦ Remove the CUx module (lefthand slot in the
electronics box) after releasing the connecting
cable to the PMU and the two retaining screws.
Use the handles to remove the module.
♦ Insert the bus expansion LBA into the
electronics box (position, refer to the diagram)
until it snaps into place.
♦ Insert the CUx module back into the lefthand
slot, screw in the retaining screws at the
handles, insert the connecting cable to the
PMU.
♦ Insert the T400 in slot 2 (right) and, if required
the option module in slot 3 (center) of the
electronics box, and screw into place.
Replacing modules in the electronics box
♦ Release the screws retaining the modules
above and below the handles.
♦ Carefully
remove
electronics box using the handles, and take
care that the module does not catch on any
adjacent components and parts.
♦ Carefully locate the new module onto the guide
rails and insert it fully into the electronics box.
♦ Tighten the module retaining screws above and
below the handles.
4
(left)
(center)
(right)
the
module
from
the
Edition 04.00
Modules
CU2 / CU3 / CUDC / CUVC / CUMC / ...
CB1 / CB2 / CBP / CBP2 / SCB1 / SCB2 / ADB / ... / empty
T400
Slot 1 1 (CU)
SLOT 3 (Options)
SLOT 2 (T400)
nd
module (second T400 or
SIMADYN D Hardware Brief Description
Siemens AG
Advertisement
Table of Contents
