Wall Control Installation - Emerson PRIMA SNUGGER CF905BS01 Owner's Manual

7.1
This control is designed to operate only one ceiling fan,
and not an accessory light kit. This wall control is rated
for 1.2 amps at 120 volts.
NOTE: The "0" position is OFF. The four fan speeds
are selected by sliding the bar to the other four
speed positions ("1", "2", "3" and "4").
N O T E : E l e c t r i c c o n n e c t i o n s s h o u l d b e i n
accordance with the National Electrical Codes and
all Local Codes. Before starting, disconnect power
to the circuit at the fuse box or circuit breaker
panel.
7.2
Remove the Faceplate and Screws from the Existing
Wall Switch. Pull Switch out from Wall Outlet Box.
Disconnect Wires from Existing Fan Wall Switch
(Figure 19).

7. Wall Control Installation

!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
!
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
SCREWS
Figure 19
12
12
WARNING
WARNING
OUTLET
WALL BOX
SWITCH
FACEPLATE
U.L. Model No.: CF905-1