Table of Contents
Advertisement
1.2
What is the ET 200R distributed I/O Device?
Definition
The ET 200R distributed I/O device is a DP slave with a protection rating of IP65.
The design permits, among others, direct mounting on the Kempf box for the pro-
cessing of welding signals.
Application area
• Its robust construction and IP65 protection rating make the ET 200R distributed
I/O device exceptionally suited to use in rugged industrial environments.
It was especially developed for use in the raw product manufacturing of the auto-
motive industry.
The ET 200R is used in the following applications:
• On the fixed part of the robot (on the arm) to non-reactively couple or decouple
PROFIBUS and to control or monitor the tool coupling with relatively few digital
inputs and outputs
• On the tool to control and monitor the handling or the welding procedure there
with relatively few digital inputs and outputs and to directly loop through the ana-
log signals of a welding tong to the welding controller. These two models will
now be called handling module and welding module.
• Two versions are available:
Repeater or handling module (ET 200R-H)
-
Welding module (ET 200R-W) – same as the handling module but with floor
-
hole and place to plug in analog signals SKÜ and KSR as well as tempera-
ture input.
Features of the ET 200R
• Compact design.
• Suitable for rugged industrial environments.
• Non-reactive coupling and decoupling of two PROFIBUS segments via inte-
grated repeater function.
• 8 parametrizable digital inputs/outputs and 8 fixed digital inputs.
• Compatible with the Kempf box (splitting box for welding applications).
• The power supply for the electronics and encoder, PROFIBUS-DP and signal
lines are fed in a common cable to the first ET 200R and then on to the next ET
200R in another common cable.
• The PROFIBUS address of the ET 200R can be set from 1 to 99 with two rotary
switches.
Distributed I/O Device ET 200R
(4)J31069-D0427-U001-A2-7618
Product Overview
1–3
Advertisement
Table of Contents
