Connecting The Bus Plugs; Figure 4-2 Ejector For The Terminal Strip; Table 4-1 Allocation Of The Terminal Field On The Back - Siemens SIMATIC ET 200R Manual

Table 4-1
Terminal No.
Removing
To remove the module, disconnect the terminal strip by lifting the ejector with a
screwdriver either one side at a time or both sides at once.
Figure 4-2
4.2.2

Connecting the bus plugs

Lightly press the cable plugs onto the cable socket and snap in the mechanical
guide of the housing. Screw the swivel nuts hand-tight.
If the bus cable is not looped through further, cover X02 with a dummy cap (acces-
sory) so that protection rating IP65 is ensured.
To remove proceed in reverse order.
Caution
Bus plug connectors X01 and X02 may only be connected or disconnected in the
load-free operating state!
Distributed I/O Device ET 200R
(4)J31069-D0427-U001-A2-7618
Allocation of the terminal field on the back
1 24 V (US1, encoder power)
2 Digital input, bit 7 (parallel to X7, pin 2)
3 0 V (US1)
4 KSR_1
5 KSR_2
6 SKÜ_1
7 SKÜ_2
Ejector for the terminal strip
Signal / Function
From outside place
screwdriver here.
Wiring
4–5