Table of Contents
Advertisement
•
Screw the front panel on the surface-mounted socket.
•
The Wall Switch should be installed in a casing suitable for the way of installation, e.g. in an installation box
which is installed on surface or concealed, etc., with a waterproof casing class of no less than IP64.
•
We recommend to place the battery holder in the same casing (located on the Wall Switch rear wall bracket)
or in a separate casing of the same waterproof class, not less than IP64.
5.3 Replacing the batteries
If the batteries are inserted incorrectly, the electronics or drive may be irreparably damaged. Only replace the batteries
when the appliance has been completely switched off.
NOTE:
If the appliance is equipped with a 230 VAC connection, no batteries are present in the receiver or in battery
box.
•
The battery are placed in battery holder which is integrated into the control unit (Wall Switch).
Copyright Planika Sp. z o.o.
www.planikafires.com
WARNING!!!
IG0115#03
16.03.2020
17
Advertisement
Table of Contents
