Installing The Speakers - Sena 10C EVO User Manual

2.1.3 Using the Glued Surface Mounting Plate
If you cannot install the clamp unit on the helmet, you can use the
glued surface mounting plate to attach the clamp unit to the surface of
the helmet.
1. Attach adhesive tape of the glued surface mounting plate to the
helmet.
2. Make sure that the glued surface mounting plate sticks on the
helmet firmly. Maximum adhesion occurs after 24 hours.
3. Attach the main unit to the glued surface mounting plate until you
hear a click.

2.2 Installing the Speakers

1. Attach the hook and loop fasteners for speakers to ear pockets
inside the helmet.
2. Attach the speakers to the hook and loop fasteners for speakers
inside the helmet.
1
1
2
Note:
1. If the helmet has deep ear pockets, you can use the speaker pads to
bring the speakers closer to your ears.
2
2. To enhance the audio quality, you can make use of the foam speaker
covers. Cover each speaker with the foam and attach the hook fastener
at the back of the speaker. Then place the speakers in the helmet as
described above. Foam covered speakers work most effectively when
they are slightly touching your ears.
10C EVO
Note
Foam
Speaker
Hook
Cover
Fastener
2
7