Sena 10S Quick Start Manual

PREPARATION
Knowing the Headset Layout Installing the Headset
Headset
Status LED Jog Dial
Clamp Unit
1
Charging LED
2
Phone Button
DC Power Charging &
Firmware Upgrade Port
1
2
Clamp Unit
3
MP3 Port
Headset
Microphone
2
Connector
1
Left Speaker
Connector
Right Speaker
Earbud Port
Connector
BASIC OPERATION
Operating the Buttons
Speaker
5
1
2
Tap the Double tap the Press and hold Press the two Rotate the
button button the button for buttons at the Jog Dial
5 seconds same time
Left
Turning On/Off the Headset
Right
ON You will hear ascending
beeps.
"Hello"
1
You will hear descending
OFF
Microphone
beeps.
"Good bye"
1
Simultaneously press and hold the Jog Dial and the Phone Button
2
for 1 second to turn on or off the headset.
Adjusting the Volume
You will hear a beep when the volume
reaches the maximum or minimum
level.
PAIRING
Checking the Battery Level Pairing with Mobile Devices - Phone, Music
Blinking 70~100%
Blinking 30~70%
0~30%
Blinking
Turn on the headset and check the battery level via the Status LED.
"High" 70~100%
3
"Medium" 30~70%
"Low" 0~30%
Or, press and hold the Jog Dial and the Phone Button for 3 more
seconds when the headset turns on. You will hear a triple beep
and a voice prompt.
Bluetooth
Sena10S
Charging the Battery
Charging
Fully charged
or
AC adapter
Using Phone Features
After Pairing...
Answering Calls
or
"Phone pairing"
Ending Calls
or
Bluetooth
"Your headset is paired"
Making Calls
Using the Phone Keypad
"Hello"
or
Rejecting Calls
until you hear a beep until you hear a beep
Using the Voice Dialer