Compound Cuts; Bevel Cut - Bosch 4410L Operating/Safety Instructions Manual

slightly to the left while rotating the bevel range
selector knob with left hand to "Max Range"
(Figure 2).
d. Tilted saw head to any angle from 47° left to 46°
right.
e. Push down bevel lock lever until you feel the lever
snap into the locked position.
Follow these instructions for making
your bevel cut:
1. Extend the base extensions on the side on which
the cut will be made. (See Sliding Fence and Base
Extension on page 25).

Compound Cuts

• A "compound cut" is a cut made with the blade set
to both an angle relative to the fence (miter angle)
and an angle relative to the base (bevel angle).
• A compound cut can be made as either a chop cut
or a slide cut depending on the width of the work-
piece.
• Because it may take several tries to obtain the
desired compound angle, perform test cuts on
scrap material before making your cut.
Follow these instructions for
making your compound cut:
1. Extend the base extensions and fences on the
side on which the cut will be made. (See Sliding
Fences and Base Extensions on page 25.)
2. Properly position workpiece. Make sure workpiece
is clamped firmly against the table or the fence.
Use clamping position that does not
! WARNING
interfere with operation. Before
switching on, lower head assembly to make sure
clamp clears guard and head assembly.
3. Set miter and bevel angles according to the
instructions on page 28 for miter and bevel cuts.
4. Follow the procedures for either chop cut or slide
cut (see page 26).
5. Wait until blade comes to a complete stop before
returning head assembly to the raised position
and/or removing workpiece.
2. Properly position workpiece. Make sure work piece
is clamped firmly against the table and the fence.
NOTE: Use clamping position that does not inter-
fere with operation.
3. Before turning the saw on, practice the cutting
action to make sure the fence clears the guards
and adjust as necessary.
4. Follow the procedures for either a chop cut or slide
cut (see page 26).
5. Wait until blade comes to a complete stop before
returning head assembly to the raised position
and/or removing workpiece.
Quick-Action
Clamp
Sliding
Bevel Angle
Base
Scale
Figure: Compound Cut
29.
Workpiece
Miter
Angle