Right 45° Bevel Stop - Bosch 4410L Operating/Safety Instructions Manual

Disconnect plug from power source
! WARNING
before performing any assembly,
adjustment or repair to avoid possible injury.
Checking Right 45°
Bevel Stop
1. Lower head assembly and engage head assembly
lock pin.
2. Slide head assembly completely to the back and
tighten the rail lock knob.
3. Rotate table to the 0° miter position.
4. Pull up bevel lock lever to unlock bevel.
5. Move bevel range selector knob to "0°-45° Right"
position. (See page 28)
6. Tilt the saw to the right until you feel the stop in the
45° right position. This is where the saw is cur-
rently set for the 45° right bevel cut.
7. Use a combination square to check blade at the
45° stop. Place the combination square head on
the table and press it's 45° surface against the
blade. If the blade does not contact the full length
of the square, (figure 1), follow the calibrating pro-
cedure.
Calibrating Right 45°
Bevel Stop
1. Lift bevel lock lever to release bevel lock.
2. Tilt saw to 45° right bevel position.
3. Position combination square with 45° surface
against blade. (Figure 1)
4. Insert 3 mm "L" wrench into hole in vertical support
frame. (Figure 2)
5. Rotate "L" wrench while viewing blade against
combination square until it matches 45° surface.
6. Adjust bevel pointer to 45° line on bevel scale.
Adjustments
(continued)
Figure 1. Right 45° Bevel Stop
3mm
"L"
Wrench
Bevel
Pointer
Figure 2. Right 45° Bevel Adjustment
14.
Combination
Square
Adjusting
Access Hole