Bosch TIS65 Series Instruction Manual page 18

en Menu
F
Important: Be sure to take note of
the section on "Service programmes".
Info Service programmes
(depending on the type of appliance)
Display how many beverages can still be
prepared before it will be necessary to run
one of the service programmes.
■ Use I to display Clean after --- c or
Descale after --- c.
■ Touch F to exit from the display.
F
For technical reasons the counter
does not represent a precise number
of cups.
Coffee-milk ratio *
The coffee-milk mixing ratio set in the
factory can be adjusted in several steps.
■ Use I to select the beverage (only
for coffee drinks with milk) and confirm
with B.
■ Use I to select the desired mixing
ratio (setting of milk content in %) and
confirm with B.
■ The setting is saved.
Example: If a value of 30% is selected,
30% milk and 70% coffee will be dispensed.
Items marked * are not present in all
models.
Favourite
The menu item Favourite can be used to
create or change personalised beverages.
The number of Favourites depends on the
model of the appliance.
■ Use I to select a new or existing
profile and confirm with B
■ Touch the desired beverage and confirm
with B.
■ Your selection for the beverage settings
appears on the display depending on the
beverage, e.g. ml or Coffee-milk ratio.
■ Make your settings and confirm with
B each time.
■ The beverage is now saved in the profile.
14
Set cup size
Set up the volume dispensed for each drink
and each size of cup. The volumes set up in
the factory can be adjusted stepwise.
■ Use I to choose a drink and touch
B to confirm your choice.
■ Use I to choose the desired volume
and touch B to confirm your choice.
The setting is then saved.
Water hardness
Set this to the hardness of the local water
supply.
Level 1, 2, 3, 4 or Softening system can be
selected. The preset level of water hard-
ness is level 4.
■ Use I to choose the desired water
hardness and touch B to confirm
your choice.
F
It is important to set the water hard-
ness correctly, so that the appliance
indicates accurately when the
descaling programme should be run.
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier. If a water softening
system is installed in the house, please
select the Softening system setting.
■ Briefly dip the test strip in the water and
check the result after one minute.
Level Water hardness
German (°dH) French (°fH)
1 1-7
2 8-14
3 15-21
4 22-30
Automatic shut-down
Setting how long the appliance should wait
after the last drink was prepared before it
automatically switches itself off.
You can specify values from 15 minutes to
3 hours. The factory setting is 30 minutes.
■ Use I to choose the desired interval
and touch B to confirm your choice.
1-13
14-25
26-38
39-54