Display; Initial Use - Bosch TIS65 Series Instruction Manual

Mains switch J
The mains switch J is used to switch the
appliance on or off. The appliance rinses
itself automatically when it is switched on
and off.
The appliance does not rinse if:
■ it is still warm when switched on, or
■ no coffee was dispensed before it was
switched off.
The appliance is ready for use when the
symbols and the display on the control
panel are lit.
Control panel (touch field)
In the control panel you can easily navigate
the controls just by touching the symbols
and characters.
You will hear an audible signal.
These audible signals can be switched on
or off (see the section "Menu – Key tones").
Drink selection
Touching the corresponding symbol
selects the desired drink (see the section
"Preparing drinks").
Start/stop button
Touching C either begins preparing
a drink or launches a service programme.
If you touch C again while the
drink is being prepared, dispensing will be
prematurely halted.
Menu
Touching A calls up the menu, the
navigation symbols will be activated and
light up. Touch I, B and F to
navigate through the menu and call up
information or change settings (see the
section "Menu").
Drink options
Touching H or D adjusts the strength or
size of the drink, touching G prepares two
cups simultaneously as soon as you touch
C to begin dispensing (see the
section "Preparing drinks").
"Favourite" and Childproof lock
Briefly touching R calls up personalised
beverages (see the section "Own settings
Favourite").
Touching R for 3 seconds or more
activates or deactivates the childproof lock
(see the section "Childproof lock").

Display

The display shows the selected drinks
and settings plus messages reporting the
appliance's operating status.
Espresso
Regular
Please refill water tank
These messages are cleared as soon as
the action has been carried out.

Initial use

General
Fill the appropriate container using only
pure, cold, uncarbonated water and solely
roasted beans. Do not use coffee beans
that have been glazed, caramelised or
treated with other additives containing
sugar, since they will block the brewing unit.
The water hardness setting on the
appliance can be adjusted. The factory
setting for the water hardness is 4. Use
the enclosed test strip to determine the
hardness of your water supply. If this
shows a value other than 4, you will need
to programme the appliance appropriately
after it has been taken into service (see
section "Menu – Water hardness").
Display en
medium
7