Samsung Wi-Fi Kit 2.0 User & Installation Manual page 7

F1 F2 V1 V2 F3 F4
3. Use two or more screws to fix the back cover to the wall. Connect the power cables (V1, V2) and
communication cables (F1, F2) to the terminals on the back of the front cover while adjusting to a suitable
length.
4. When connecting the power cables to V1 and V2, fasten the PCB terminal screws (CN5) to a torque of
6 N·cm or less.
Screw size: M3 x 6
• You can connect up to 16 indoor units to a Wi-Fi Kit.
NOTE
10 and over
10 and
over
50 and over
※ Be sure to secure space of at least
10 mm (up/right/left) and 50 mm
(down) around the back cover
before fixing the back cover on
the wall.
Item
ⓐ Power/communication terminals
ⓑ Tracking/Reset button
ⓒ Micro SD card slot
5. Assemble the Wi-Fi Kit again.
• Insert the front cover to the upper grooves as shown in the figure. After assembly,
make sure that there is no gap between the covers.
NOTE
SOL OCF Wi-Fi KIT 구통신 유럽향 IBIM_EN_DB68-08417A-00_.indd 7
Unit: mm
10 and over
Screw
holes
Back over
※ Fix the screws to the
screw holes.
Contents
F1 F2 V1 V2 F3 F4
ⓔ
※ Do not over-tighten the PCB
terminal.
Item Contents
ⓓ LED
ⓔ Network PBA
ⓕ Interface module PBA
Indoor unit
ⓕ
Wi-Fi Kit
ⓑ
ⓓ
ⓒ
ⓐ
PCB port
V1 V2 F1 F2
7
2019-06-21 오후 4:11:42