Magtek DYNAMAG Demo Manual page 10

2 - How to Connect Bluetooth LE devices to a Windows Host
After a few seconds the device will disconnect, which is normal power-saving behavior.
13) Use the host software to test swiping a card. If you do not yet have host software and the device is
configured to run in KB mode, open any text editor and swipe a card. The card contents should
appear in the text editor.
14) The device consumes very little power when not transmitting card data, so it is not necessary to
power off the device to conserve power. If the device appears as
list of Bluetooth devices, swiping a card should cause the device to reconnect briefly, transmit the
card data, then disconnect.
15) Remember to change the default password. See the DynaMAX Programmer's Reference documents
for details.
To unpair from the device:
1) Locate the device in the
2) Press the
Remove device
DYNAMAG, DYNAMAX, EDYNAMO, UDYNAMO, ADYNAMO, MDYNAMO, TDYNAMO, DYNAWAVE| SCRA Devices | MTNET Demo Guide
Page 10
Manage Bluetooth devices
button.
Not connected
window.
in the Windows