Nordson Rhino SD3 Instruction Sheet

Single-post container hold-down

Hide thumbs Also See for Rhino SD3:

Download this manual

Rhino

Description

Container Hold-Down

Figure 1

Container Hold-Down

E 2018 Nordson Corporation

SD3/XD3 Single-Post Container

WARNING: Allow only qualified personnel to perform the following tasks. Follow

the safety instructions in this document and all other related documentation.

See Figure 1. The Rhino

material container in place during a container change.

SD3/XD3 container hold-down is used to secure the

Instruction Sheet

P/N 1610314−03

Hold-Down

Part 1610314−03

10016501

Page 1 Description See Figure 1. The Rhino SD3/XD3 container hold-down is used to secure the material container in place during a container change. Container Hold-Down 10016501 Figure 1 Container Hold-Down Part 1610314−03 E 2018 Nordson Corporation...
Page 2 4. Use the six screws (6) included in the container hold-down kit to secure the container hold-down to the base plate (5). Tighten to 18 ft-lb (24 NSm). 10015733 Figure 2 Container Hold-Down Installation Part 1610314−03 E 2018 Nordson Corporation...
Page 3 8. Loosen the four screws (1) and adjust the lateral adjustment bracket (4) until it it almost touches the material container. 9. Tighten the four screws (1) to 7 ft-lb (9.5 NSm). 10015733 Figure 3 Container Hold-Down Adjustment Part 1610314−03 E 2018 Nordson Corporation...
Page 4 AR: As Required NS: Not Shown Issued 7/18 Original copyright date 2018. Rhino, Nordson, and the Nordson logo are registered trademarks of Nordson Corporation. All other trademarks are the property of their respective owners. Part 1610314−03 E 2018 Nordson Corporation...

Rhino xd3