Nordson Rhino SD2 Manual

Description
See Figure 1 and refer to Table 1. The J-Box module
provides the interface between the Rhino SD2/XD2 bulk
unloader electrical components and the system
controller. The J-Box module mounts
Two-Hand Operation Control Module.
The J-Box module is designed for two-hand operation.
The operator controls (1) enable ram movement. Both
2-HAND CONTROL push buttons must be pressed at the
same time to enable the bulk unloader ram movement.
Refer to the Using the Ram Controls section for
a functional description of the operator controls.
Figure 1 J-Box Module Components
Item Description
PURGE Momentary push button for purging material from the inactive pump during drum changes.
2-HAND CONTROL
Enables/disables ram movement.
LEFT/RIGHT
RAM DIRECTION Ram movement:
S
S
S
NOTE: The Neutral position does not mechanically lock the ram. Air pressure remains in the
ram cylinders. Small air leaks in the circuit can cause the ram to drift upward or downward.
Never leave the bulk unloader in the Neutral position to perform maintenance, or when it is
not in use for long periods of time. When performing maintenance, make sure that the ram
and follower plate is on the bulk unloader base or secured using support blocks.
DRUM
Illuminates when a drum is positioned under the follower plate.
IN POSITION
E 2019 Nordson Corporation
Rhino
to
the Rhino XD2
3
2
Table
1 Operator Controls
Ram Up raises the ram and follower plate.
Neutral stops ram movement and pneumatically locks the rams.
Ram Down lowers the ram and follower plate.
r
SD2/XD2 Two-Hand Operation
J-Box Module with Ethernet
The cables (2) provide the electrical interface between
the J-Box, limit switches, proximity sensors, and control
valves.
PURGE
2-HAND CONTROL RAM DIRECTION
LEFT NEUTRAL
DOWN
DRUM
IN POSITION
1
2-HAND CONTROL
RIGHT
UP
Part 1615331−01