Delivery Contents; Operation Startup; Assemble The Blade; Assemble The Saw Chain - Grizzly EKS 2200 QT Translation Of The Original Instructions For Use

back
Helps you to catch spring-backs
with specially developed control
systems.
8 Metal stop claw
Reinforces the stability when
vertical cuts are carried out and
facilitates sawing.
10 Electric
Double insulated for safety rea-
sons.
11 On-off switch with safety
chain brake
On releasing the On/Off switch, the
device immediately switches
12 Switch-on block
The switch-on block must be re-
leased for switching on the device.
13 Chain catcher
Decreases the danger of injuries if
the chain breaks or if it comes off.

Delivery contents

- Chainsaw
- Blade (guide rail)
- Saw chain
- Protective blade holder
- 180 ml Grizzly bio oil
- Instruction Manual

Operation startup

Always wear protective gloves
when working with the chainsaw
and employ only original parts.
Pull out the power plug before
doing any work on the chainsaw
itself -– injury hazard!
Before initial operation of the electric chain-
saw, you must assemble the blade, chain
and chain wheel cover, adjust the chain,
fill with chain oil, check the function of the
chain brake and check the oil mechanism.
motor
Caution! The saw can re-oil.
Please note that the saw re-oils after use
and oil may leak out if it is stored on its side
or on the head. This is a normal process
due to the necessary ventilation opening
on the upper edge of the tank and does
not constitute a reason for complaint. As
each saw is checked during production and
tested with oil, a small residue may be in
the tank despite draining, which may slightly
dirty the housing with oil in transit. Please
clean the housing with a cloth.
off.

Assemble the blade

1. Place the saw on a flat surface.
2. Turn the fixing screw (15) anti-
3. Place the blade (5) on the rail

Assemble the saw chain

1. Spread the saw chain in a loop,
2. Place the chain around the chain
3. Pretension the chain by turning
4. Attach the chain wheel cover
clockwise to remove the chain
wheel cover (16).
bolts so the tensioning screw (21)
points outwards.
so the cutting edges face clock-
wise (6).
cog (22) and insert into the blade
groove. It is normal for the saw
chain to sag.
the tensioning screw (21) clock-
wise.
(16). Here, the lug on the cover
must initially be inserted into the
notch provided on the device for
this purpose (23). Tighten the fix-
ing screw (15) only slightly, as the
saw still has to be tensioned.
UK
145