All Rights Reserved (805) 522-5555 www.johnsoncontrols.com No part of this document may be reproduced without the prior permission of Johnson Controls, Inc. These instructions are supplemental. Often they are supplemental to other manufacturer’s documentation. Never discard other manufacturer’s documentation. Publications from Johnson Controls, Inc.
Page 3
Boot disk failure recovery (see page 33) Quick start checklist (see page 33) ACKAGE ONTENTS Thank you for choosing the Johnson Controls DVN 5000 Desktop Series server. DVN 5000 DESKTOP USB FLASH DRIVE: SERIES SERVER TRAINING DVD • Client Software •...
POWER LED INDICATOR Uninterruptible Power Supply (UPS) Johnson Controls strongly recommends providing power to the DVN 5000 Desktop unit via a listed UPS for temporary, backup power in the event of a power failure. Recommended Manufacturer: APC® Recommended UPS Minimum Wattage and Volt-Amperes Rating:...
DVN model, manufacturing date code, country where the unit was assembled, and a warning statement. This sticker must be affixed to the unit and intact to receive warranty service on a defective DVN unit at a Johnson Controls authorized repair facility.
DVN 5000 does not supply power to a condenser microphone). Enable a microphone in the DVN software as the left channel for each audio input. Refer to the DVN 5000 Series Software Installation and Configuration Manual for assistance. 24-10129-55 Rev. C This document contains confidential and proprietary information of Johnson Controls, Inc.
Page 16
ERVER ETUP UTLINE For detailed information on how to perform each step, refer to the DVN 5000 Series Software Installation and Configuration Manual. To power on the server: 1. Press the main power button on the front of the unit.
27 for more information. 4. Click the Login button to log into the server. When you configure your DVN 5000 Series server for the first time, the default password will remain undefined until you specify it. For security reasons, we highly recommended that you set the administrator’s...
Page 21
The selected encoder setting determines the values in the Encoder Type, Encoder Resolution, and Encoder Rate fields. Refer to the DVN 5000 Series Software Installation and Configuration Manual for more information on configuring cameras. To configure network cameras: Network cameras are only supported on DVN 5000 servers running software Version 2.7 or higher.
Page 24
PTZ dome tours Sectors For detailed procedures, refer to the DVN 5000 Series Software Installation and Configuration Manual. 1. On the RemoteControl Main screen, click Setup. 2. On the Setup screen, click Scheduler. The Record Scheduler screen appears.
Page 25
(24 hours). As an alternative, you can grant the user access for limited or multiple time intervals. Refer to the DVN 5000 Series Software Installation and Configuration Manual for details. 4. Use the Camera drop-down list to select the camera whose sector(s) you wish to configure.
Page 29
Software Installation and Configuration Manual. 2. On the Setup>System Configuration screen, click the Clear and Shutdown button. 3. Obtain a valid authorization number from Johnson Controls. See “Contact Information” on page 2. 24-10129-55 Rev. C This document contains confidential and proprietary information of Johnson Controls, Inc.
Desktop Series server. The checklist provides only the essential steps required to get the DVN 5000 up and running. Detailed configuration instructions and additional features are covered elsewhere in this document and in the DVN 5000 Series Software Installation and Configuration Manual (24-10248-5).
Need help?
Do you have a question about the DVN 5000 Series and is the answer not in the manual?
Questions and answers