Indicator Lamp In The Charging Station - McCulloch ROB S400 Operator's Manual

Message Cause
Guide calibration
The product has succeeded to calibrate
accomplished
the guide wire.
6.4 Indicator lamp in the charging
station
The indicator lamp in the charging station must show a solid or flashing green light for a correct
installation. If not, follow the instructions in the troubleshooting guide below.
You can also find information on www.mcculloch.com. Speak to your customer service for more
information.
Light Cause
Green solid light Good signals
Green flashing
The signals are good and
light
activated.
Blue flashing light
The boundary loop is not connected to
the charging station.
Break in the boundary loop.
Yellow flashing
The guide wire is not connected to the
light
charging station.
Break in the guide wire.
Red flashing light
Interruption in the charging station's an-
tenna.
Red solid light
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an au-
thorized service technician.
44 - Troubleshooting
Action
No action required.
Action
No action required
ECO mode is
No action required. For more informa-
ECO mode . Refer to ECO mode
tion on
on page 28 .
Check that the boundary wire connec-
tors are fitted properly to the charging
station. Refer to
wire on page 20 .
Find out where the break is. Replace
the damaged section of the loop with a
new loop wire and splice using an origi-
nal coupler.
Check that the guide wire connector is
properly connected to the charging sta-
tion. Refer to
on page 21
Find out where the break is. Replace
the damaged section of the guide wire
with a new loop wire and splice using
an original coupler.
Contact customer service.
Contact customer service.
To install the boundary
To install the guide wire
1411 - 001 - 18.12.2019