Operation; The On/Off Button; To Start The Product; Operating Modes - McCulloch ROB S400 Operator's Manual

4.1 The ON/OFF button

WARNING: Read the safety
instructions carefully before you start
the product.
WARNING: Keep your hands and feet
away from the rotating blades. Never
put your hands or feet close to or
under the machine when the motor is
running.
WARNING: Do not use the product
when persons, especially children, or
animals, are in the work area.
• Push the ON/OFF button for 3 seconds to
switch on the product. The product is active
when the indicator lamp on the keypad is lit.
• Push the ON/OFF button for 3 seconds to
switch off the product.
4.1.1 The indicator lamp
WARNING: It is only safe to carry out
inspection or maintenance on the
product when the product is disabled.
The product is disabled when the lamp
on the keypad is not lit.
The indicator lamp on the keypad is an important
status indicator:
• The product is active if the indicator lamp
lights continuously.

30 - Operation

4 Operation
• The product is in standby if the indicator
lamp flashes. This means that the operator
must push the ON/OFF button for 3 seconds
to make the product active again.
• The product is disabled when the indicator
lamp is not lit.

4.2 To start the product

1. Open the hatch to the keypad.
2. Push the ON/OFF button for 3 seconds. The
display is lit up.
3. Use the up/down arrow buttons and the OK
button to enter the PIN code.
4. Push the START button to start to mow in
the main area.
Note: If another operating mode is desired,
push the START button and confirm with the
OK button. Refer to
page 30 .
5. Close the hatch.
Note: If the product is parked in the charging
station, the product will only leave the charging
station when the battery is fully charged and if the
schedule allows the product to operate.

4.3 Operating modes

When the STAR button is pressed the following
operating modes can be selected:
• Secondary area (2nd area)
• Power Cut
• Spot Cut
Operating modes on
1411 - 001 - 18.12.2019