Installation Of The Product - McCulloch ROB S400 Operator's Manual

• Put the guide wire minimum cm / ft. from the
boundary wire (B).
• Starting point (C). Refer to
page 27 .
• Minimum distance cm / ft. perpendicular to
the guide wire (D). If less distance, the
calibration process is interrupted. For the
widest possible guide corridor, have a
minimum distance of m / ft. Refer to
calibration on page 23 .
• Where the guide wire is connected to the
boundary wire (E).
• Guide corridor (F). The product always runs
to the left of the guide wire as seen facing
the charging station. Make sure that the
guide wire has as much free area as
possible to the left of the guide wire.
Note: The product runs at different distances
to the guide wire but stays in the guide
corridor.
3.4.5 Work area examples
• If the charging station is put in a small area
(A), make sure that the distance to the
boundary wire is at a minimum 2 m / 6.6 ft.
in front of the charging station.
• If the work area has a passage (B), make
sure that the distance to the boundary wire
is at a minimum 2 m / 6.5 ft. If the passage is
smaller than 2 m / 6.5 ft., install a guide wire
through the passage. Minimum passage
between the boundary wire is 60 cm / 24 in.
• If the work area has areas which are
connected by a narrow passage (B), you
can set the product to first follow and then
leave the guide wire to the point it connects
to the boundary wire (C). The settings can
Lawn Coverage on page 26 .
be changed in
• If the work area includes a secondary area
To make a secondary area on
(D), refer to
page 18 . Put the product in the secondary
Secondary area mode .
area and select
1411 - 001 - 18.12.2019
Starting point on
Guide

3.5 Installation of the product

3.5.1 Installation tools
•
•
•
•
3.5.2 To install the charging station
D
B
C
Hammer/plastic mallet: To simplify putting
the stakes into the ground.
Combination pliers: For cutting the boundary
wire and pressing the connectors together.
Adjustable plier: For pressing the couplers
together.
Edge cutter/straight spade: To bury the
boundary wire.
WARNING: Obey national regulations
about electrical safety.
WARNING: The product is only to be
used with the power supply unit
supplied by .
A
Installation - 19