McCulloch ROB S400 Operator's Manual page 18

type of obstacle. However, obstacles that slope
slightly, for example stones or large trees with
raised roots, must be isolated or removed. The
product can run onto this kind of obstacle causing
the blades to be damaged. Use the boundary
wire to isolate areas inside the work area by
creating islands. When the boundary wires to and
from the island are put close together, the
product can run over the wire.
Note: To achieve careful and silent operation, it is
recommended to isolate all fixed objects in the
work area.
• Put the boundary wire to and around the
obstacle to make an island.
• Put the 2 sections of boundary wire that run
to and from the obstacle close together
without crossing.
• Put the 2 sections of boundary wire in the
same stake.
0 cm / 0"
3.4.3.4 To make a secondary area
Make a secondary area (B) if the work area has 2
areas that are not connected with a passage. The
work area with the charging station is the main
area (A).
Note: The product must be manually moved
between the main area and the secondary area.
18 - Installation
B
A
• Put the boundary wire around the secondary
area (B) to make an island. Refer to
make an island on page 17 .
Note: The boundary wire must be put as 1
loop around all of the work area (A + B).
Note: When the product cuts grass in the
secondary area, the
must be selected. Refer to
on page 30 .
3.4.4 To examine where to put the guide
wire
Put the guide wire from the charging station
through the work area and connect it to the
boundary wire. The installation of the guide wire
is important for a successful guide calibration,
Guide calibration on page 23 .
refer to
A
D
C
• Put the guide wire in a line at a minimum of
m / ft. in front of the charging station (A).
To
Secondary area mode
Operating modes
E
B
F
1411 - 001 - 18.12.2019