BLOTZ B28-OW-203 Instructions

28mm privy #1

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember

to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Remove the base and front of the seat from the sprue.

Take the back wall and seat upper.

Glue the back wall to the base.

Take the front wall from the sprue.

28mm Privy #1

B28-OW-203

Please read these instructions fully before starting construction.

Glue together as shown above.

Glue the seat upper to the reverse of the back wall.

Check the detailing is facing the right way (see pic).

Carefully insert the door handle into the space in the

door. Leave to dry.

Glue it to the base as shown.

Table of Contents

Need help?

Do you have a question about the B28-OW-203 and is the answer not in the manual?

Page 1 28mm Privy #1 B28-OW-203 Please read these instructions fully before starting construction. PVA or equivalent glue will be required to stick sections together. Sand paper can be used to gently clean any joints. A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember to cut away from yourself at all times.
Page 2 The two side walls… .. are then glued into position – high edge towards the front of the privy.. The door, upper support and rear piece. Place the upper support on top of the door, then insert the lower peg of the door into the hole in the base.