BLOTZ B28-VSF-013 Instructions

Plateau Martian Prowler
B28-VSF-013
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
You may find it easier to paint sections of your model as you go along prior to the final assembly (see below).
Take the pieces shown above from the sprue.
The deck and keel.
The turn the model over and glue the keel to the
underside. It will project through the deck at the
stern.
Glue them together as shown with the smallest
piece at the bottom.
Add the deck to the model.
The wing supports are formed from the pieces
show on the left. Glue them together as shown on
the right.