Status Indications - iDTRONIC BLUEBOX ADVANT UHF Manual

This section provides details on the status indications of the BLUEBOX.
The BLUEBOX uses one bicolor green/red LED. The following tables provides
the indicator states and flash rates.
LED State
On
Off
Flickering
Blinking
Single flash
Double flash
Triple flash
Quadruple flash
Operating Status
Preoperational
Preoperational
and tag detected
Operational
Operational and
tag detected
Stopped
B5U033000E
6

Status Indications

Description
The LED shall be constantly on.
The LED shall be constantly off.
That shall indicate the iso-phase on and off with a frequency of
approximately 10 Hz: on for approximately 50 ms and off for
approximately 50 ms.
That shall indicate the iso-phase on and off with a frequency of
approximately 2,5 Hz: on for approximately 200 ms followed by off for
approximately 200 ms.
That shall indicate one short flash (approximately 200 ms) followed by
a long off phase (approximately 1000 ms).
That shall indicate a sequence of two short flashes (approximately 200
ms), separated by an off phase (approximately 200 ms). The sequence
is finished by a long off phase (approximately 1000 ms).
That shall indicate a sequence of three short flashes (approximately 200
ms), separated by an off phase (approximately 200 ms). The sequence
is finished by a long off phase (approximately 1000 ms).
That shall indicate a sequence of four short flashes (approximately 200
ms), separated by an off phase (approximately 200 ms). The sequence
is finished by a long off phase (approximately 1000 ms).
LED red
Off
Off
Off
Off
Off
LED green
Blinking
Blinking alternately
with yellow LED
On
Off
Flashes (single
flash)
LED yellow
Off
Blinking alternately
with green LED
Off
On
Off
Page 42 of 54