iDTRONIC BLUEBOX ADVANT UHF Manual page 23

Sub-Index Parameter
05h Q Value
06h Q Initial
07h
Q Adjust
08h
Inventory
09h
0Ah Session
0Bh
0Ch EPC size
ReadAfterDete
0Dh
ct Password
ReadAfterDete
0Eh
ct Bank
ReadAfterDete
0Fh
ct Address
ReadAfterDete
10h
ct Length
ReadAfterDete
11h
ct Flags
B5U033000E
Description
The Q value used in fixed Q selection algorithm or the starting Q
value used in dynamic Q selection algorithm as defined in EPC Class
1 Generation 2 protocol (0 ... 15).
The minimum allowed Q value in dynamic Q selection algorithm
mode (0 ... 15)
The maximum allowed Q value in dynamic Q selection algorithm
Q Final
mode (0 ... 15)
The maximum Q adjust rounds in dynamic Q selection algorithm
Rounds mode (0 ... 5)
The inventory cycles in inventory command (0 ... 5).
Cycles
The session used as defined in EPC Class 1 Generation 2 protocol:
•
•
•
•
The target used as defined in EPC Class 1 Generation 2 protocol:
Target •
•
The size of the recognized EPC in bytes. 0, 2, 4, ... 62. 0 means all
EPC sizes.
The password to be used to access to tag's memory in
ReadAfterDetect mode (Inventory Mode = Standard Single/Multi Tag
with Custom Info). Use a '0' password if the access password is not
requested.
The tag's memory bank to access in ReadAfterDetect mode
(Inventory Mode = Standard Single/Multi Tag with Custom Info):
•
•
•
•
The tag's memory start address to access in the specified memory
bank in ReadAfterDetect mode (Inventory Mode = Standard
Single/Multi Tag with Custom Info).
The number of tag's memory blocks (2-bytes length) to access in the
specified memory bank in ReadAfterDetect mode (Inventory Mode =
Standard Single/Multi Tag with Custom Info). In case of Reserved or
User bank selected 0 means no tag's memory block access, in case
of TID bank selected 0 means auto-length (class identifier,
manufacturer identifier, serial number).
The tag's info (PC, EPC, CRC) to include in the tag's ID in
ReadAfterDetect mode (Inventory Mode = Standard Single/Multi Tag
with Custom Info). A byte whose bits are dedicated to disable (0
value) or enable (1 value) functions:
0x00: S0
0x01: S1
0x02: S2
0x03: S3
0x00: A
0x01: B
0x00: Reserved
0x01: EPC
0x02: TID
0x03: User
Page 23 of 54