For Serviceman - Baxi Assure Mono 5 Operation User's Manual

OPERATION PARAMETER
OPERATE MODE
CURRENT
COMPRESSOR FREQUNCY
COMP. RUN TIME1
COMP. RUN TIME2
COMP. RUN TIME3
OPERATION PARAMETER
COMP.RUN TIME4 1000 Hrs
EXPANSION VALVE
FAN SPEED 600 R/MIN
IDU TARGET FREQUENCY
FREQUENCY LIMITED TYPE
T1 LEAVING WATER TEMP.
OPERATION PARAMETER
T1B CIRCUIT2 WATER TEMP.
T2 PLATE F-OUT TEMP.
T2B PLATE F-IN TEMP.
T3 OUTDOOR EXCHANGE TEMP.
T4 OUTDOOR AIR TEMP.
T5 WATER TANK TEMP.
OPERATION PARAMETER
Ta ROOM TEMP.
Th COMP. SUCTION TEMP.
Tp COMP. DISCHARGE TEMP.
TW-O PLATE W-OUTLET TEMP.
TW-I PLATE W-INLET TEMP.
P1 COMP. PRESSURE
OPERATION PARAMETER
T1S' C1 CLI. CURVE TEMP.
T1S2' C2 CLI. CURVE TEMP.
TF MODULE TEMP.
SUPPLY VOLTAGE
POWER CONSUM. 1000 kWh
DC GENERATRIX VOLTAGE
OPERATION PARAMETER
DC GENERATRIX CURRENT
WATER FLOW
HEAT PUMP CAPACITY
HMI SOFTWARE 00-00-2000V00
IDU SOFTWARE 00-00-2000V00
ODU SOFTWARE 00-00-2000V00
1/6
COOL
12 A
24 Hz
54 MIN
65 MIN
10 MIN
2/6
240 P
0 HZ
0
25 °C
3/6
30 °C
30 °C
45 °C
-7 °C
-7 °C
-7 °C
4/6
25 °C
25 °C
25 °C
25 °C
25 °C
200 kPa
5/6
25 °C
25 °C
55 °C
230 V
420 V
6/6
18 A
1.72 M3/H
11.52 kW
20
INFORMATION
i
The power consumption parameter is optional.
if some parameter not be activated in the
system, the parameter will show "--"
The heat pump capacity is for reference only, not
used to judge the ability of the unit. The accuracy
of sensor is ±1 . The flow rates parameters are
calculated according to the
parameters,the deviation is different at different flow
rates,the maximum of deviation is 15%.

6.9 For Serviceman

6.9.1 About For Serviceman
FOR SERVICEMAN is used for installater and service
engineer.
Setting the function of equipment.
Setting the parameters.
6.9.2 How To Go To For Serviceman
Go to ''MENU'' > ''FOR SERVICEMAN''. Press ''OK''.
FOR SERVICEMAN
Please input password:
2 3 4
ENTER ADJUST
OK
The FOR SERVICEMAN is used for installer or service
engineer. It is NOT instended the home owener alters
setting with this menu.
It is for this reason password protection is requierd to
prevent unauthorised access to the service settings.
The password is 234.
6.9.3 How To Exit For SERVICEMAN
If you have set all the parameter.
Press ''BACK'', the following page will appear：
FOR SERVICEMAN
Active the setting and exit?
NO
CONFIRM ADJUST
OK
Select ''YES'' and press ''OK'' to exit the FOR
SERVICEMAN.
After exiting the FOR SERVICEMAN, the unit will be
turned off.
pump running
YES