Grundfos Hydro 2000 Solo-E Quick Manual
Grundfos Hydro 2000 Solo-E Quick Manual

Grundfos Hydro 2000 Solo-E Quick Manual

Advertisement

1~ Hydro Multi-E
1
2
Hydro 2000 Solo-E

Installation

2
1
1: Expansion joints
2: Pipe hangers

Electrical connection

GRUNDFOS INSTRUCTIONS
The Hydro 2000 Solo-E booster set must
be installed in a well ventilated room to
ensure adequate cooling of the pump.
Hydro 2000 Solo-E is not suitable for
outdoor installation.
2
Do not start the booster set until it has
been filled with water and vented.
1
2
To avoid resonance, expansion joints and
pipe hangers should be fitted on both
sides of the booster set.
The electrical connection must be car-
ried out by an authorized electrician in
accordance with local regulations.
The electricity supply must be con-
nected to the on/off switch of the
booster set.
Quick Guide
i

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hydro 2000 Solo-E and is the answer not in the manual?

Questions and answers

Summary of Contents for Grundfos Hydro 2000 Solo-E

  • Page 1 1~ Hydro Multi-E GRUNDFOS INSTRUCTIONS Hydro 2000 Solo-E Quick Guide Installation The Hydro 2000 Solo-E booster set must be installed in a well ventilated room to ensure adequate cooling of the pump. Hydro 2000 Solo-E is not suitable for outdoor installation.
  • Page 2 Being responsible is our foundation Thinking ahead makes it possible Innovation is the essence Setpoint setting The setpoint is set by means of the control panel on the motor terminal box. Set the desired setpoint by pressing the button “+” or “–”. Green (operation) Red (fault) [bar]...

Table of Contents