Height Of Cut Adjustment - Ransomes Mastiff 91 Safety, Operation & Maintenance Manual

9 ADJUSTMENTS
9.1

HEIGHT OF CUT ADJUSTMENT

The cutting height is determined by the position of the
front rolls in relation to the bottom blade; variation of
this setting is made by adjusting the front roll:
1. Loosen the bolts securing the front roll brackets
on both sides of the machine.
2. Set the roll at the required height - raise the
height of cut by lowering the front roll and
reverse the procedure to reduce the height of
cut. Check that the setting is the same onboth
sides of the machine.
3. Tighten the bolts.
NOTE: The front roll should never be set so that the
bottom blade is pressing on the turf; this will damage
the spiral cutters, bottom blade and the turf.
9.2 HANDLE (PEDESTRIAN MACHINE ONLY)
The height of the handle can be adjusted to suit the
operator. Always raise the handle when fitting and
using the trailing seat to give clearance for legs over
undulating ground.
To adjust:
1. Slacken the clamp bolts
2. Move the handle to the required height.
3. Re-tighten the bolts.
GB-36
SAFETY, OPERATORS & MAINTENANCE MANUAL