Clutch Controls; Removing The Cutting Cylinder And Bottom Blade Assembly; Removing The Landroll Assembly - Ransomes Mastiff 91 Safety, Operation & Maintenance Manual

9 ADJUSTMENTS
9.7

CLUTCH CONTROLS

The clutch controls have been accurately set. Should
any adjustments be necessary contact your local
service centre.
9.8 REMOVING THE CUTTING CYLINDER AND
BOTTOM BLADE ASSEMBLY
1. Remove the chaincase and the cylinder drive
chain.
2. Tilt the machine back until it rests on the
handles. Ensure ithe machine is fully supported
before continuing
3. Remove the front roll by extracting the pivot
studs (A) and adjusting bolts (B) from both sides
of the machine.
4. Remove the three cylinder housing screws (C)
from both sides of the machine.
The complete cutting unit will then slide out. Re-
assemble in reverse order.
9.9

REMOVING THE LANDROLL ASSEMBLY

1. Places wedges under the side frames for
support.
2. Remove the chain cover and landroll drive chain.
3. Disconnect brake cable by removing the split pin
and pin which connects the lower end of the
cable to the brake lever.
4. Remove the bolts securing the landroll bearing
housings (D) at both sides of the machine.
The landroll assembly will then slide out.
Re-assemble in reverse order
SAFETY, OPERATORS & MAINTENANCE MANUAL
GB-39