Table of Contents
Advertisement
7.2
CUTTING UNIT HEIGHT OF CUT ADJUSTMENT ____________________________
TO ADJUST SPANNER TYPE:
1.
Turn adjuster (A) at the rear of the unit clockwise to reduce the height of
cut, or anticlockwise to increase the height of cut. The grooves (B) are
used as an rough indicator for setting the roll parallel.
7.3
FLOATING HEAD FRONT ROLL SETTING (SPORT 200) ______________________
1.
The right hand end of the front roll is fixed. To set the roll parallel to the
bottom blade rotation of an eccentric clamping nut (A)
front roll bearing housing is necessary.
2.
Slacken left hand roll bearing housing clamping bolts (B).
3.
Rotate the eccentric nut (A) to give the desired parallelism of the roll to
the bottom blade.
4.
While still holding the eccentric nut (A) from rotating tighten the roll
bearing housing clamping bolts (B).
ADJUSTMENTS 7
on the left hand
A
B
A
B
en-57
Advertisement
Table of Contents
