Connecting Charger To Power Supply; Charging The Battery - Stihl BGA 100 Instruction Manual

English
Removing the Nozzle
Rotate the nozzle (1) clockwise as
N
far as the stop.
Pull the nozzle (1) off the blower
N
tube (2).
8
Connecting Charger to
Power Supply
Power supply (mains) voltage and
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.

Charging the Battery

A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
2
Connect the charger to the power
1 N
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger only in enclosed
and dry rooms at ambient temperatures
between +5°C and +40°C (40°F and
104°F).
Only charge dry batteries. Allow a damp
battery to dry before charging.
Charging STIHL AR Battery
For a description of the complete
charging process on the STIHL AR
battery see STIHL AR battery instruction
manual.
BGA 100