Interactive Fire Alarm System
Fire Alarm Control Panel, BS-310/320
NOTE: To operate the panel, turn
the key to the left
(Access Level 2).
Protecting life, environment and property...
Release 3
Operator Panel, BS-330
P-ASAFE-SH/LE, Rev. A, 010531
In the Event of a Fire Alarm
One or several fire detectors or manual call points
in one or several detection zones are signalling a
Fire Alarm.
FIRE ALARMS
1 OFFICES
2 CANTEEN
3 WORKSHOP
(Display Picture - Example)
Step
Actions to be taken - Operation Mode
1
Follow all precautions described in the
local fire instructions, step by step.
2
To silence the internal buzzer, press the
black Mute Panel button
3
Press
4
Observe the zone(s) in Alarm state on the
display.
If you need to find out more detailed zonal / point
information before investigating the scene(s), follow the
General Procedure, Step 4, a) to e) on the last page of
this folder, How to View Detailed Information.
If not, go directly to step 5.
5
Investigate the scene(s) and carry out the
necessary actions.
6
To silence all alarms, press the red
Silence Alarms button
To manually resound the alarm zones, digit 1
(RESOUND) can be pressed.
When the fire is extinguished and all necessary repair
work is implemented (smoke is exhausted, new glass
replaced in the manual call-points, etc.), the system
should be returned to normal operating mode.
7
Press the green Reset button
If there are points still signalling an alarm after system
reset and no actions are taken, the points will
automatically be reactivated after a predefined timeout.
If you want to disable the point(s) before timeout - for
example, a manual call-point still signalling alarm -,
press
A point can also be reactivated (digit 3) at any time after
the disablement. To reset the system, repeat step 6 and
7.
19:23
Total: 3
Need help?
Do you have a question about the AUTROSAFE Self Verify BS-310 and is the answer not in the manual?
Questions and answers