Special Mode - Denon AVR-X3000 Service Manual

SPECIAL MODE

Special mode setting button
b No.1 - 5, 7, 8 : Press the "Power operation ( X )" button to turn on the power while pressing both the buttons A and the button B at the
same time.
b No.6 : Turn on the power, then press and hold down the A and B buttons for over 3 seconds.
No. Mode
Version display
1
(μcom/DSP Error Display)
User Initialization mode
2 (Installer Setup settings are not
initialized.)
Factory Initialization mode
3 (Installer Setup settings are also
initialized.)
PANEL/REMOTE LOCK Selection
4
mode
5 Service Related Selection mode
6 Remote ID Setup mode
Mode for switching tuner frequency
7 step
(E2 model Only)
8 Installer Setup mode
Button A Button B
STATUS DIMMER
TUNER TUNER
PRESET CH PRESET CH
+ –
ZONE2
DIMMER
SOURCE
TUNER
ZONE2
PRESET CH
SOURCE
+
ZONE2
DIMMER
SOURCE
STATUS DIMMER
TUNER
PRESET CH DIMMER
+
TUNER
ZONE2
PRESET CH
SOURCE
-
ZONE2 ON/OFF
TUNER PRESET CH – DIMMER
TUNER PRESET CH +
ZONE2 SOURCE
X
18
Button C
Firmware versions such as Main or DSP are
- displayed in the FL Display. Errors are displayed
when they occur. (Refer to
Backup data initialization is carried out.
-
(Installer Setup settings are not initialized.)
Backup data initialization is carried out.
-
(Installer Setup settings are also initialized.)
Selects to reject operations through panel buttons
- and the master volume knob on the main unit and
operations via the remote control.
Selects the "Diagnostic mode" or "Displaying the
STATUS
protection history mode". (Refer to
When using multiple DENON AV receivers in
the same room, make this setting so that only
-
the desired AV receiver operates. (Refer to
page)
- Change tuner frequency step to FM:50kHz/200kHz
Access the Remote Maintenance mode via the
internet.Installer Setup is displayed on GUI/Option
-
Menu.
b Refer to AVR_RemoteMaintenance_.pdf of SDI.
STATUS
Contents
21 page)
54 page)
57