Denon AVR-X3000 Service Manual page 69

Error
Details of Error code
Code
NACK was received when "L"
5B command sent to Sub CPU, DSP,
PLD etc.
Sub CPU, DSP, PLD etc. failed to
5C receive firmware for rewriting sent
from DM860A (when timed out).
Sub CPU, DSP, PLD etc. failed
to receive firmware for rewriting
5D
sent from DM860A (when an error
occurred).
Data in firmware such as Sub CPU,
DSP and PLD for rewriting sent
5E
from DM860A was invalid (when a
Check Sum error occurred).
Invalid data in firmware such
as Sub CPU, DSP and PLD for
5F
rewriting sent from DM860A was
invalid (invalid data was received).
NACK was received when "P"
60 command sent to Sub CPU, DSP,
PLD etc.
NACK was received when "I"
61 command sent to Sub CPU, DSP,
PLD etc.
62 Start of Sub µ-com fail.
Acquisition of serial flash data
80 failed before serial flash was
deleted.
Deleting data failed before serial
81
flash was rewritten.
Receiving firmware for rewriting
82 serial flash sent by DM860A failed
(when timed out).
Receiving firmwarefor rewriting
83 serial flash sent by DM860A failed
(when an error).
Receiving firmwarefor rewriting
84 serial flash sent by DM860A failed
(when a Check Sum error).
Receiving firmwarefor rewriting
85 serial flash sent by DM860A failed
(when invalid data was received).
The data verification was invalid
86
after serial flash was rewritten.
Acquisition of (Application Mode)
A0 IP address failed before rewriting
DM860A was rewritten (AutoIP).
Display
U p d a t i n g f a i l
U p d a t i n g f a i l
U p d a t i n g f a i l
U p d a t i n g f a i l
U p d a t i n g f a i l
U p d a t i n g f a i l
U p d a t e C h e c k N G
U p d a t i n g f a i l
U p d a t i n g f a i l
U p d a t i n g f a i l
U p d a t i n g f a i l
U p d a t i n g f a i l
U p d a t i n g f a i l
U p d a t i n g f a i l
U p d a t i n g f a i l
C o n n e c t i o n F a i l A 0
69
Coping strategies
Turn off and on the power. Updating starts
5 B
automatically.
Turn off and on the power. Updating starts
5 C
automatically.
Turn off and on the power. Updating starts
5 D
automatically.
Turn off and on the power. Updating starts
5 E
automatically.
Turn off and on the power. Updating starts
5 F
automatically.
Turn off and on the power. Updating starts
6 0
automatically.
Turn off and on the power. Updating starts
6 1
automatically.
Turn off and on the power. Updating starts
6 2
automatically.
Turn off and on the power. Updating starts
8 0
automatically.
Turn off and on the power. Updating starts
8 1
automatically.
Turn off and on the power. Updating starts
8 2
automatically.
Turn off and on the power. Updating starts
8 3
automatically.
Turn off and on the power. Updating starts
8 4
automatically.
Turn off and on the power. Updating starts
8 5
automatically.
Turn off and on the power. Updating starts
8 6
automatically.
Check the network connection.
Carry out the update in an environment that
has little network load.