Mitsubishi Electric MELSEC iQ-R Series User Manual page 87

RH42C4NT2P DC input/transistor output combined module
Item
 Input specifications
Number of input points
Rated input voltage
Rated input current
ON voltage/ON current
OFF voltage/OFF current
Input resistance
Response time
Wiring method for common
Interrupt function
 Output specifications
Number of output points
Rated load voltage
Maximum load current
Maximum inrush current
Leakage current at OFF
Maximum voltage drop at ON
Response time OFFON
ONOFF
Surge suppressor
Fuse
External power Voltage
supply
Current
Wiring method for common
Protection Overload
functions protection
Overheat
protection
 Common specifications
Withstand voltage
Isolation resistance
Noise immunity
Protection degree
Number of occupied I/O points
External interface
Internal current consumption (5VDC)
Weight
■Derating chart (input circuit)
(50,32)
Y
■
32
28
24
20
16
12
8
4
0 10 20 30 40 50
Specifications
32 points
24VDC (ripple ratio: within 5%) (allowable voltage range: 20.4 to 28.8VDC)
4.0mA TYP. (at 24VDC)
19V or higher/3mA or higher
6V or lower/1.0mA or lower
5.3k
Page 86 Input response time
32 points/common (common terminal: 1B01, 1B02)
Positive/negative common shared type
Available (can be set in the "Module Parameter")
32 points
12/24VDC (allowable voltage range: 10.2 to 28.8VDC)
0.2A/point, Pilot Duty, 2A/common
Current is to be limited by the overload protection function.
0.1mA or lower
0.2VDC (TYP.) 0.2A, 0.3VDC (MAX.) 0.2A
0.5ms or less
1ms or less (rated load, resistive load)
Zener diode
None
12/24VDC (ripple ratio: within 5%) (allowable voltage range: 10.2 to 28.8VDC)
16mA (at 24VDC)/common
32 points/common (common terminal: 2A01, 2A02)
Sink type
Limited current when detecting overcurrent: 1 to 3A/point
Activated to each point. ( Page 84 I/O combined module)
Activated to each point. ( Page 84 I/O combined module)
510VACrms, 1 minute
10M or higher by isolation resistance tester
Simulator noise 500Vp-p, noise width 1s,
noise frequency 25 to 60Hz (noise simulator condition)
IP2X
32 points (I/O assignment: I/O combined 32 points)
40-pin connector
Page 105 40-pin connector type module
220mA (TYP. all points ON)
0.13kg
(55,32)
■ (55,24)
X
55
●: Input voltage 26.4V
: Input voltage 28.8V
X: Ambient temperature ()
Y: Number of simultaneous on points (point)
3.1 Performance Specifications
Appearance
3 SPECIFICATIONS
3
85