Mitsubishi Electric MELSEC iQ-R Series User Manual page 84

RY42PT1P transistor output module
Item
Number of output points
Rated load voltage
Maximum load current
Maximum inrush current
Leakage current at OFF
Maximum voltage drop at ON
Response time OFFON
ONOFF
Surge suppressor
Fuse
External power Voltage
supply
Current
Withstand voltage
Isolation resistance
Noise immunity
Protection degree
Wiring method for common
Number of occupied I/O points
Protection Overload
functions protection
Overheat
protection
External interface
Internal current consumption (5VDC)
Weight
■Circuit configuration
The figure below shows the case of 32 points in the first half (F). The case of 32 points in the latter half (L) is the same.
Internal
circuit
Left side connectors
(first half)
Indication
SW
selector
Right side connectors
circuit
(last half ) *1
*1 The LED indicates the first half (Y00 to Y1F) by turning the switch to the left (F), while the LED indicates the latter half (Y20 to Y3F) by
turning the switch to the right (L).
3 SPECIFICATIONS
82
3.1 Performance Specifications
Specifications
64 points
12/24VDC (allowable voltage range: 10.2 to 28.8VDC)
0.1A/point, Pilot Duty, 2A/common
Current is to be limited by the overload protection function.
0.1mA or lower
0.1VDC (TYP.) 0.1A, 0.2VDC (MAX.) 0.1A
0.5ms or less
1ms or less (rated load, resistive load)
Zener diode
None
12/24VDC (ripple ratio: within 5%) (allowable voltage range: 10.2 to 28.8VDC)
19mA (at 24VDC)/common
510VACrms, 1 minute
10M or higher by isolation resistance tester
Simulator noise 500Vp-p, noise width 1s,
noise frequency 25 to 60Hz (noise simulator condition)
IP2X
32 points/common (common terminal: 1B01, 1B02, 2B01, 2B02)
Source type
64 points (I/O assignment: Output 64 points)
Limited current when detecting overcurrent: 1 to 3A/point
Activated to each point. ( Page 51 Output modules)
Activated in increments of 2 points. ( Page 51 Output modules)
40-pin connector
Page 105 40-pin connector type module
290mA (TYP. all points ON)
0.13kg
1B20 Load
1A05 Load
12/24VDC
1B01,1B02
Constant-voltage
circuit
1A01.1A02
Appearance